Thirty-two switches simulate the digital outputs from, any Gilderfluke & Co. digital output card (Br-ZBrick, Br-MultiBrick32)
Green LEDs clearly show each digital output
If an output is shorted, then a red LED will turn on instead of the normal green LED to indicate a wiring problem. All outputs are PTC circuit breaker protected from short circuits and damage
Digital outputs that are shorted to their neighbors can easily be seen (two LEDs are turned on)
Four ‘Power’ outputs on the J6/A connector are PTC circuit breaker protected
Digital output wiring tester. Through the years we have found that when there is a problem with a system during installation, that most times an output wiring problem caused it. These testers can be used during a new installation or on any existing show to test for wiring problems.
The Tester-J6 card will plug in place of a digital output card (Br-ZBrick or Br-MultiBrick32). The Tester-J6 sends open collector switch to ground signals to simulate any digital output card.
Thirty-two switches simulate the digital outputs from, any Gilderfluke & Co. digital output card (Br-ZBrick, Br-MultiBrick32)
Green LEDs clearly show each digital output
If an output is shorted, then a red LED will turn on instead of the normal green LED to indicate a wiring problem. All outputs are PTC circuit breaker protected from short circuits and damage
Digital outputs that are shorted to their neighbors can easily be seen (two LEDs are turned on)
Four ‘Power’ outputs on the J6/A connector are PTC circuit breaker protected
The indicator LEDs clearly show each ‘Power’ output
Any shorts on the ‘Power’ outputs are indicated by a red LED